Home  |   Deutsch  |   English  |   Français  |   Print

Blowing-in devices

Blowing-in devices are used to blow pull cords into tube systems. The pull cords are required for pulling in small cables or the pre-rope.
 

> Cord blowing-in device EZ 15

  • Blowing a special cord into microtubes (inner tube diameter 4 to 20 mm)
  • For optical fibre technology
  • For installations in residential, trade and industrial buildings
  • Highly suitable for shorter distances , e.g. from the distribution box to the house or into the room
  • Easy to operate, ready for use  
  • Light and compact, fits in all car boots 
  • For use with a commercially available compressor 200-300 l/min (not included in the scope of delivery)
  • Fast rope retrieval (500 m in 30 s)
  • Excellent accessibility – also if space is very tight
  • Equipped with safety couplings and overpressure protection
  • Excellent cost-performance ratio

page up
> Cord blowing-in device EZ 50

  • Blowing-in or suction of a pull cord without a compressor
  • For commercially available electrical tubes (inner tube diameter 18 to 50 mm)
  • Suitable for flexible tubes
  • For installations in residential, trade and industrial buildings
  • Considerable time-saving when pulling the cable in
  • Easy device operation
  • Several hundred metres' cord retrieval possible
  • Compact device 
  • Excellent accessibility, also if space is very tight
  • Light and compact; fits in all car boots
  • Double function: blowing in/suction
  • Strong in case of feed problems
  • Excellent cost-performance ratio

page up
> Cord blowing-in device EZ 100

  • Blowing-in or suction of a pull cord (up to a tensile strength of 300 kg) without a compressor
  • For commercially available cable protection tubes (inner tube diameter from 50 to 150 mm)
  • Possible with special accessories for small tubes with an inner diameter of at least 25 mm
  • For installations in the ground as well as road, tunnel and bridge construction
  • Pull-in lengths also exceeding 1000 m (current record 3280 m)
  • Considerable time-saving when pulling the cable in
  • Cleaning, discharging water, calibration and pulling-in the line in a single operation cycle
  • Compact device, fits in all car boots
  • Excellent accessibility, also if space is very tight
  • Light and compact, easy device operation
  • Double function: blowing-in/suction
  • Excellent price/performance ratio

page up
> Cord blowing-in device EZ 300

  • Blowing-in or suction of a pull cord (up to a tensile strength of 300 kg) without a compressor
  • Independent of electricity thanks to the two-stroke engine
  • For commercially available cable protection tubes (inner tube diameter from 25 to 200 mm)
  • For installations in residential, trade and industrial buildings, as well as road, tunnel and bridge construction, cable car construction and for mountain railways
  • Pull-in lengths also exceeding 1000 m (current record 2850 m)
  • Considerable time-saving when pulling the cable in
  • Cleaning, discharging water, calibration and pulling-in the line in a single operation cycle
  • Compact device, fits in all car boots
  • Excellent accessibility, also if space is very tight
  • Light and compact, easy device operation
  • Double function: blowing-in/suction
  • Excellent price/performance ratio

page up